63 10... Adjust the low-beam headlight (with electronic headlight adjustment device MAHA Lite 3)

WARNING: This page is about a different variant/trim than selected.

COMPLY WITH TEST PREREQUISITES FOR HEADLIGHT ADJUSTMENT!

Refer to the operating instructions for the headlight adjustment device!

NOTE: On vehicles with anti-glare high-beam headlight it is sufficient to adjust the low-beam headlight.
Only in the event of a customer complaint regarding dazzle/glare Adjust anti-glare high-beam headlight separately.

Switch on the headlight adjustment device by pressing any button.

Press F2 button. The shown display screen appears.

Perform the following settings:

Passenger car must be selected
Enter the setting dimension of the headlight via the buttons F1/F2: - 1, 0 % to - 1, 1 % . See LIGHT/DARK BOUNDARY OF THE HEADLIGHT IN ADJUSTMENT DEVICE .
The right/left-hand traffic must be selected according to the country.
Select the headlight type via the button F3:
- EC: for halogen and xenon headlights
- EC LED: for LED headlight
  
  Fig 1: Display - Headlight Adjustment Screen
  Courtesy of BMW OF NORTH AMERICA, INC.

The adjusted values are adopted for future measurements.

Fig 2: Display - LED Headlight Adjustment Screen

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Before measuring/adjusting the low-beam headlight, it is absolutely necessary to determine the TRANSPARENT SCREEN OF THE HEADLIGHT !
An incorrect selection leads to an incorrect setting!

Transparent screen Type I:

Press briefly the button for the applicable side of the vehicle (3) until symbol (1) appears.

Transparent screen Type II:

Press longer the button for the applicable side of the vehicle (3) until symbol (4) appears.

The following symbols appear in the display:

O. K. (2): Adjustment is optimal.
O. K. (5): Adjustment is within the legal tolerance range. ADJUST HEADLIGHT until O. K. (2) is displayed.
Arrows (6): Adjustment is incorrect. ADJUST HEADLIGHT using arrows (6) until O. K. (2) is displayed.