2. General Notes For Embossed Vehicle Identification Numbers

WARNING: This page is about a different variant/trim than selected.

This procedure is used for all vehicles on which the vehicle identification number can not be stamped.

For the repair new parts with an embossed vehicle identification number can as a rule be ordered from the BMW Parts Department. If this is not possible, observe country-specific regulations.

The IGEF number (bodyshell number) is omitted when the wheel arch is replaced.

If a VIN is embossed into the replacement surface in addition to the original VIN (e.g. if the original VIN has been tampered with), the following applies: The vehicle-specific repair instructions describe the procedure.

The protective film used as standard is omitted after the VIN has been embossed. Paint area in accordance with BMW Painting Handbook. Ensure that layer thicknesses are small.

Observe national/country-specific regulations.