LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2011 >> 335i 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 39 (Collision - Body Panel Repair (E90)) >> Body Panel Repair General Information >> 41 00... Opening Rivet Connections >> 2. Opening Punch Rivets >> 2.2 Opening Punch Rivets By Drilling Out

2.2 Opening Punch Rivets By Drilling Out

WARNING: This page is about a different variant/trim than selected.

Drill out rivets with a 6 mm dia. carbide drill bit.

Punch rivets can be drilled out on both sides. When drilling from the protruding rear side, spot-drill the rivet shank only and remove the rest with a rivet punch.

NOTE: Sand down and even out remaining burr on the rear side. Deburr bore holes.

Use a drift punch to remove punch rivet remnants in the aluminium (risk of corrosion).

Clean vehicle to remove swarfs (risk of corrosion).

scientia non olet · About LEMON Manuals