1. Aluminium
WARNING: This page is about a different variant/trim than selected.
| Hazards/effects |
Measures/regulations |
Repair stage 1 and 2:
No hazards/effects |
none |
Repair stage 3: (Welding - only E52)
- Explosion hazard due to high concentration of fine aluminium dust.
Arising e.g. during straight-through grinding of coated components in the base material and large-surface grinding of bright-finish components.
- Explosion hazard due to swirling up of fine aluminium dust in cavities.
Created by the necessary, thorough cleaning of machining surfaces and tools before and after machining aluminium.
|
- Avoid high concentration of fine aluminium dust by means of continuous extraction.
- Use explosion-proof exhaust extraction unit
- Do not use compressed air when cleaning the workbay.
- Avoid swirling up dust when cleaning the workbay.
|
|
|
- Do not operate ignition and fire sources in the intake area of exhaust extraction unit.
|