52 26 303 Removing and installing/replacing actuator for left or right rear seat backrest (through-loading system)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Unclip Bowden cable (1).

Unfasten screws (2).

Unlock catch (3) to centre of vehicle and at same time unclip actuator (4) towards bottom.

If necessary, unclip actuator (4) with special tool 00 9 317 .

Fig 1: Unclipping Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) and (2) of actuator (3) must not be damaged.

Bowden cable (4) must be correctly engaged in actuator (3).

Fig 2: Identifying Actuator, Bowden Cable, Catches

Courtesy of BMW OF NORTH AMERICA, INC.