52 26 200 Removing and installing/replacing rear panel on right rear seat back

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks

Lever backrest cover welt all round out of backrest frame using special tool 00 9 317 .

Fig 1: Levering Backrest Cover Welt Using Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.

Detach rear panel (2) with flat scraper (1) from rear seat back.

Installation:

Comply with instructions issued by manufacturer of universal spray adhesive.

Apply universal spray adhesive to rear panel and rear seat back.

Fit and align rear panel within the air drying time (see manufacturer's instructions).

Observe and adhere to curing time to prevent rear panels from slipping.

Fig 2: Detaching Rear Panel Using Flat Scraper From Rear Seat Backrest

Courtesy of BMW OF NORTH AMERICA, INC.