52 26 199 Removing and installing/replacing rear panel on left rear seat back
WARNING: This page is about a different variant/trim than selected.
Special tools required:
Necessary preliminary tasks
- Remove REAR SEAT BACK .
- Remove COVER STRIP .
Remove SKI BAG .
Lever out welt of backrest cover with special tool 00 9 317 on all sides from backrest frame.
Fig 1: Pulling Out Welt Of Backrest Cover With Special Tool 00 9 317 On All Sides From Backrest Frame
Detach rear panel (2) with flat scraper (1) from rear seat back.
Installation:
Comply with instructions issued by manufacturer of universal spray adhesive.
Apply universal spray adhesive to rear panel and rear seat back.
Fit and align rear panel within the air drying time (see manufacturer's instructions).
Observe and adhere to curing time to prevent rear panels from slipping.