52 24... Removing and installing/replacing all guide sleeves for rear head restraints
WARNING: This page is about a different variant/trim than selected.
Special tools required:
Necessary preliminary tasks
- Remove head restraint . See 52 24 388 REMOVING AND INSTALLING/REPLACING REAR MIDDLE HEAD RESTRAINT or 52 24 390 REMOVING AND INSTALLING OR REPLACING LEFT OR RIGHT REAR HEAD RESTRAINT from rear seat.
NOTE:
Guide sleeves cannot be removed without being damaged.
Guide sleeves with locks have two retaining lugs.
Guide sleeves with locks have two retaining lugs.
Insert special tool 52 0 070 into guide hole of sleeve (2) up to upper area of retaining lug.
Feed release tongue of special tool into rear gap on retaining lug (1).
Turn tool to release sleeve (2) and pull out towards top.
On guide sleeves with locks, unlock the second retaining lug with a screwdriver.