67 31 501 Removing and installing/replacing drive unit for longitudinal seat adjustment

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Unfasten plug connection (1) and disconnect.

Fig 1: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Bend metal tab (1) open.

Fig 2: Identifying Metal Tab

Courtesy of BMW OF NORTH AMERICA, INC.

Lift drive (1) and flex shaft (2) out of guide (4) in direction of arrow.

Detach drive (1) from rubber mounts (3).

Detach flex shaft (2) from drive (1).

Fig 3: Detaching Flex Shaft From Drive

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 4: Identifying Short Flex Shaft And Long Flex Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide short flex shaft (1) into longitudinal seat adjustment gearing square.

Bend long flex shaft (2) upwards and slide into longitudinal seat adjustment gearing.

Clip motor and flex shafts into carrier plate.

Make sure flex shafts are correctly seated in gearboxes.