67 61 005 Replacing drive with gear (front) for actuating slide/tilt sunroof

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

NOTE: Secure drive with gear for actuating slide/tilt sunroof (3) against falling out.

Unfasten plug connection (1) and disconnect.

Release screws (2), tightening torque 54 13 1AZ .

NOTE: Screws (2) are microencapsulated.

Remove drive with gear for actuating slide/tilt sunroof (3).

Fig 1: Identifying Sunroof, Screws And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert gear wheel (1) of drive with gear for actuating slide/tilt sunroof (2) exactly in gear teeth (3).

Fig 2: Identifying Gear Wheel, Slide/Tilt Sunroof And Gear Teeth

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: