34 11 667 Precision-turning both front brake discs on both sides: Notes
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Always precision-turn both sides of both brake discs on one axle.
Observe MAX. MACHINING DIMENSION PER FRICTION RING SIDE and MINIMUM BRAKE DISC THICKNESS (MIN TH) .
Brake discs of M models (Compound brake discs) must not be machined!
Only one brake pad set may be used up on brake discs which have been lathe-turned to MINIMUM THICKNESS (MIN TH) .
Observe MAX. MACHINING DIMENSION PER FRICTION RING SIDE and MINIMUM BRAKE DISC THICKNESS (MIN TH) .
Brake discs of M models (Compound brake discs) must not be machined!
Only one brake pad set may be used up on brake discs which have been lathe-turned to MINIMUM THICKNESS (MIN TH) .