61 71 015 Removing and installing/replacing a spray nozzle in windscreen washer system

WARNING: This page is about a different variant/trim than selected.

NOTE: The jet nozzles of the windscreen washer system are preset at the factory and cannot be readjusted.

Necessary preliminary tasks:

Press detent lug (1).

Detach unlocked plug housing (2) in direction of arrow.

Detach hose (3) from spray nozzle.

Fig 1: Detaching Unlocked Plug Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Release spray nozzle (1) in direction of arrow from cowl panel cover and remove.

Installation:

Make sure spray nozzle (1) is correctly seated.

Fig 2: Releasing Spray Nozzle

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of spray nozzle (4) must not be damaged or missing:

1 Plug connection
2 Hose connection
3 Detent lug, bottom
5 Detent lug, top

Fig 3: Identifying Spray Nozzle, Plug And Hose Connection
Courtesy of BMW OF NORTH AMERICA, INC.