61 31 221 Removing and installing/replacing both multifunction steering wheel switches

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

NOTE: Both multifunction steering wheel switches (1) are connected to each other by the wiring.

Disconnect plug connection (2).

Pull multifunction steering wheel switches (1) in direction of arrow out of steering wheel.

Feed wiring out of steering wheel and remove both multifunction steering wheel switches.

Fig 1: Pulling Multifunction Steering Wheel Switches

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure electrical leads are correctly routed.

Installation:

Guides (2) of multifunction steering wheel switches (1) must be correctly seated in corresponding locators (3) on steering wheel.

Fig 2: Identifying Guides Of Multifunction Steering Wheel Switches

Courtesy of BMW OF NORTH AMERICA, INC.