Stripping insulation from optical fibre

WARNING: This page is about a different variant/trim than selected.

Open hand pliers (1).

Open lever (2) in direction of arrow.

Fig 1: Identifying Hand Pliers And Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Slide optical fibre (1) into stripping device (2) until flush at point (3).

Close hand pliers (4) fully.

Close clamping lever (5) in direction of arrow.

Open hand pliers (4) by one tooth notch.

Open clamping lever (5) against direction of arrow again and remove optical fibre (1).

NOTE: A stripping replacement blade set is available under number 61 4 327.

Fig 2: Sliding Optical Fiber Into Stripping Device

Courtesy of BMW OF NORTH AMERICA, INC.