61 33 050 Removing and installing/replacing left fanfare horn
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove FRONT LEFT WHEEL ARCH COVER
Slacken nut (1). Tightening torque 61 33 1AZ .
Remove fanfare (2) from holder (3).
Disconnect associated plug connection.
NOTE:
The electromechanical fanfare is installed as standard equipment. Only in China, India, Russia,
South Africa and the Gulf States is the electronic fanfare installed as of 01/2011.
South Africa and the Gulf States is the electronic fanfare installed as of 01/2011.
- Electromechanical fanfare
- Electronic fanfare
Distinguishing features:
- Electromechanical fanfare has a black connector (1)
- Electronic fanfare has a white connector (3)
- Only the electromechanical fanfare has a small adjusting screw (2)
- Holder (4) is vehicle-specific and may differ by vehicle from the graphic.
IMPORTANT:
In vehicles with a production data before
01/2011, both
fanfares must be replaced in the countries listed above.
The electronic fanfare has a different sound pattern.
Combining the mechanical and electronic fanfares is not permissible.
The connector position may vary slightly.
It is particularly important to ensure that the holder is firmly seated on the vehicle and the fanfare is firmly seated on the holder! The effect on sound is very high!
If the new part is supplied with the holder included, this must be replaced completely with the holder!
The electronic fanfare has a different sound pattern.
Combining the mechanical and electronic fanfares is not permissible.
The connector position may vary slightly.
It is particularly important to ensure that the holder is firmly seated on the vehicle and the fanfare is firmly seated on the holder! The effect on sound is very high!
If the new part is supplied with the holder included, this must be replaced completely with the holder!