61 14 010 Removing and installing/replacing distribution box (on battery)

WARNING: This page is about a different variant/trim than selected.

WARNING: Observe SAFETY INSTRUCTIONS for handling vehicle battery.

Necessary preliminary tasks:

Release screws (1) and remove bracket (2). Tightening torque 61 14 1AZ .

Fig 1: Identifying Bracket And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unlock plug housing (2) and release in direction of arrow.

Fold up covers on nuts (3).

Unscrew nuts (3). Tightening torque 61 21 2AZ .

Disconnect plug connection (4).

Disconnect plug connection of IBS cable (5).

Fig 2: Disconnecting Plug Connection Of IBS Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Press locking brackets (2) downwards and unclip.

If necessary, using a screwdriver (1), expand locking bracket (2) at lower end and clip out.

Remove power distributor (3) towards top.

Fig 3: Pressing Locking Brackets, Downwards And Unclip

Courtesy of BMW OF NORTH AMERICA, INC.