SI number

WARNING: This page is about a different variant/trim than selected.

01 05 90 (207)

Consisting of:

6 = 0492316 Synchronising key
NOTE: For installing rear rubber mount in rear axle support/model series: E31
5 = 0492315 Nut
NOTE: (Nut with bearing) Model series: E31, E36, E38, E46, E60, E61, E63, E64, E65, E66, E67, E85, RR1 Replaced by 33 3 012/0 496 554
4 = 0492314 Spindle
NOTE: For removing and installing rubber mount Model series: E31, E36, E38, E46, E60, E61, E63, E64, E65, E66, E67, E85, RR1 Replaced by 33 3 011/0 496 553
3 = 0492313 Synchronising key
NOTE: For installing rubber mount at rear

Fig 1: Identifying Spindle And Synchronising Key (0492310)

Courtesy of BMW OF NORTH AMERICA, INC.

In conjunction with: 33 4 180

NOTE: (Press-out/-in tool set) For removing and installing rubber mounts in rear axle final drive mount, front and rear

01 05 90 (207)

Consisting of:

6 = 0492316 Synchronising key
NOTE: For installing rear rubber mount in rear axle support/model series: E31
5 = 0492315 Nut
NOTE: (Nut with bearing) Model series: E31, E36, E38, E46, E60, E61, E63, E64, E65, E66, E67, E85, RR1 Replaced by 33 3 012/0 496 554
4 = 0492314 Spindle
NOTE: For removing and installing rubber mount Model series: E31, E36, E38, E46, E60, E61, E63, E64, E65, E66, E67, E85, RR1 Replaced by 33 3 011/0 496 553
3 = 0492313 Synchronising key
NOTE: For installing rubber mount at rear axle final drive lid - model series: E31, E36, E38 For removing rubber mount at rear axle final drive cover - model series: E46
2 = 0492312 Synchronising key
NOTE: For removing rubber mount at rear axle final drive lid/model series: E31, E36, E38, E60, E61, E63, E64, E65, E66, E67, RR1
1 = 0492311 Holding sleeve
NOTE: (Locator sleeve) For removing and installing rubber mount/model series: E31, E36