LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2011 >> 335i 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Rear Axle - Special Tools - E90) >> Rear Axle >> 33-1300 Extractor >> 0492096 331300 Extractor Mechanical tool >> Storage Location

Storage Location

WARNING: This page is about a different variant/trim than selected.

Z4

Y4

Fig 1: Identifying Extractor (0492096)
G09834862Courtesy of BMW OF NORTH AMERICA, INC.

Consisting of:

  1. 2 = 0492108 Synchronising key
    NOTE: For pulling the bearing inner race off the drive flange - Series: E36/5 Discontinued, only available via complete tool
  2. 1 = 0492107 Washer
    NOTE: (Disc) Discontinued, only available via complete tool
  3. 9 = 0492105 Synchronising key
    NOTE: For rear axle differential and for installing the camshaft sprocket on the crankshaft (M70) Discontinued, only available via complete tool
  4. 8 = 0492104 Synchronising key

    Note:

  5. 7 = 0492103 Synchronising key
    NOTE: Not available individually. Only via complete tool set
  6. 6 = 0492102 Synchronising key

    Note:

  7. 5 = 0492101 Synchronising key
    NOTE: (Thrust piece (old)) Discontinued, only available via complete tool
  8. 4 = 0492100 Washer
    NOTE: (Disc) Replaced by 33 1 311. (0 492 107)
  9. 3 = 0492099 Washer
    NOTE: (Disc) Replaced by 33 1 311. (0 492 107)
  10. 2 = 0492098 Washer
    NOTE: (Disc) Replaced by 33 1 311. (0 492 107)
  11. 1 = 0492097 Connector
    NOTE: (Basic body) For transmissions S5D 260Z, S5D 310Z and S5D 320Z;Discontinued, only available via complete tool


Z4

Y4

Fig 1: Identifying Extractor (0492096)
G09834863Courtesy of BMW OF NORTH AMERICA, INC.

Consisting of:

  1. 2 = 0492108 Synchronising key
    NOTE: For pulling the bearing inner race off the drive flange - Series: E36/5 Discontinued, only available via complete tool
  2. 1 = 0492107 Washer
    NOTE: (Disc) Discontinued, only available via complete tool
  3. 9 = 0492105 Synchronising key
    NOTE: For rear axle differential and for installing the camshaft sprocket on the crankshaft (M70) Discontinued, only available via complete tool
  4. 8 = 0492104 Synchronising key

    Note:

  5. 7 = 0492103 Synchronising key
    NOTE: Not available individually. Only via complete tool set
  6. 6 = 0492102 Synchronising key

    Note:

  7. 5 = 0492101 Synchronising key
    NOTE: (Thrust piece (old)) Discontinued, only available via complete tool
  8. 4 = 0492100 Washer
    NOTE: (Disc) Replaced by 33 1 311. (0 492 107)
  9. 3 = 0492099 Washer
    NOTE: (Disc) Replaced by 33 1 311. (0 492 107)
  10. 2 = 0492098 Washer
    NOTE: (Disc) Replaced by 33 1 311. (0 492 107)
  11. 1 = 0492097 Connector
    NOTE: (Basic body) For transmissions S5D 260Z, S5D 310Z and S5D 320Z;Discontinued, only available via complete tool
scientia non olet · About LEMON Manuals