Storage Location

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Device (0491850)

Courtesy of BMW OF NORTH AMERICA, INC.

Consisting of:

9 = 0491859 Bush
NOTE: (Bush) Deletion, only available via tool set
8 = 0491858 Bush
NOTE: (Bush) For installing the rubber mount in the front axle support and thrust piece, for removing and installing the rubber mount in the wishbones
7 = 0491857 Bush
NOTE: For installing the rubber mount in the front axle support - series: E12
6 = 0491856 Synchronising key
NOTE: For removing and installing the rubber mount in the front axle support - series: E12
5 = 0491855 Washer
NOTE: (Flanged washer) For centring of threaded spindle and as a support disc for removing and installing the rubber mount in the front axle support and in the wishbones - series: E12
4 = 0491854 Pipe
NOTE: (Support tube) For installing the rubber mount in the front axle support - series: E12
3 = 0491853 Bush
NOTE: (Bush) For removing the rubber mount from the front axle support, for removing and installing the rubber mount in the wishbones and for press-fitting the taper roller bearing of the rear axle differential housing
2 = 0491852 Bush
NOTE: (Slip bush) For installing the rubber mount in the front axle support
1 = 0491851 Spindle
NOTE: With 2 nuts and 2 washers