33 41 000 Replacing drive flange on left or right rear axle shaft (on 2-flow exhaust system)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
Necessary preliminary tasks
- Remove OUTPUT SHAFT .
- Remove BRAKE DISK .
- Remove PULSE GENERATOR .
IMPORTANT:
Check sensor head and line from pulse generator prior to installation for external damage, replacing if necessary.
Force drive flange with special tools 33 2 116 /33 2 201, 33 2 160 , 33 4 200 and 5 wheel bolts out of wheel bearing.
NOTE:
Rounded inside edge of special tool 33 2 160
must point to drive flange.
IMPORTANT:
The wheel bearing is destroyed when the drive flange is removed and cannot be reused!
Replace WHEEL BEARING .
Installation:
Install OUTPUT SHAFT .
Oil drive flange lightly and attach to splines of output shaft.
Draw DRIVE FLANGE INTO WHEEL BEARING .
After installation:
- Adjust HANDBRAKE .