31 21 Wheel Bearings and Steering Knuckle
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - WHEEL BEARINGS AND STEERING KNUCKLE
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Wheel bearing to swivel bearing | E81/E82/E87/E88/E90/E91/E92/E93 | M12 | Replace screws | 110 Nm |
| E84 | M12 | Replace screws | |||
| Jointing torque | 80 Nm | ||||
| Torque angle | 90 ° | ||||
| 2AZ | Drive flange to axle shaft | E90/Allrad, E91/Allrad, E92/Allrad | M27 | Replace collar nut, lightly oil contact surface | 420 Nm |
| E84 | M16 | Replace collar screw and spring. No oil is permitted on the collar screw. |
|||
| Jointing torque | 210 Nm | ||||
| Torque angle | 90 ° | ||||