Rear Brake, BMW, E90
WARNING: This page is about a different variant/trim than selected.
REAR BRAKE DISCS SPECIFICATION
| Important! Installation of new brake pads is approved only provided that the brake disc thickness exceeds the specified dimension for "MIN TH" (see table). Brake discs must be replaced when they reach the nominal thickness (see table) minus 2.4 mm! (Not applicable to perforated brake discs and M vehicles) . Applies only to M vehicles and perforated ventilated brake discs: The brake discs must be replaced once they wear to the nominal specified thickness (see table) minus 1.6 mm! . Depending on:
different brake discs can be fitted The brake discs must always be assigned by way of the relevant vehicle identification number and the Electronic Parts Catalogue! |
||
| Different thicknesses on brake linings | Max. mm | 0.01 |
| Nominal size (diameter x thickness) | mm | 350x24 |
| (MIN TH) is stamped in brake disc chamber | mm | 22.4 |
| Nominal size (diameter x thickness) | mm | 336x22 |
| Nominal size (diameter x thickness) | mm | 324x22 |
| (MIN TH) is stamped in brake disc chamber | mm | 20.4 |
| Nominal size (diameter x thickness) | mm | 300x20 |
| Brake disk minimum thickness (MIN TH) stamped on brake disk body | mm | 18.4 |
| Nominal size (diameter x thickness) | mm | 296x10 |
| (MIN TH) is stamped in brake disc chamber | mm | 8.4 |
| Wear warning from residual lining thickness | mm | 3.7 |