LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2011 >> 335d >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission -- Repair >> 2414 Mechanical Attachments >> 2414001 Replacing selector shaft seal (GA6HP26Z/6HP32Z) >> Necessary preliminary tasks

Necessary preliminary tasks

E65/M67TU only

Release screws.

Remove transmission underguard (1).

Remove left diesel particulate filter.

Fig 1: Identifying Transmission Underguard
G04759406Courtesy of BMW OF NORTH AMERICA, INC.

E65/N62 only:

Release screws.

Remove transmission underguard (1).

Remove left oxygen sensor.

E60/E63/E64, N62 only:

Remove rear underbody protection.

Remove left oxygen sensor (N62 only).

Fig 2: Removing Transmission Underguard
G04755666Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: Version 1: 
Unfasten nut.
Remove cable (1).

Installation: 

Adjusting cable:

NOTE: Version 2: 
Grip clamping sleeve (1) and slacken nut (2).
Tightening torque 25 16 2AZ .
Detach retainer (3) towards bottom using a screwdriver.
Pull cable (4) out of holder.

Installation: 

ADJUST SELECTOR LEVER  .

Fig 4: Identifying Grip Clamping Sleeve, Slacken Nut, Detach Retainer And Pull Cable
G04726075Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: Version 3: 
Release shift cable head (2) from ball head.

Installation: 

Adjust selector lever.

Illustration similar.

Fig 5: Adjusting Selector Lever
G04726124Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten nut.

Take off holder (1).

Tightening torque 24 51 1AZ .

NOTE: Illustration shows E65.
Fig 6: Identifying Take Off Holder
G04755670Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 24 5 361 until it is firmly connected with shaft seal.

Fig 7: Identifying Screw In Special Tool (24 5 361)
G04726125Courtesy of BMW OF NORTH AMERICA, INC.

Screw special tool 24 5 362 onto special tool 24 5 361 and tighten down.

This pulls the shaft seal out of the transmission housing.

Fig 8: Identifying Special Tool (24 5 361) And Screw Special Tool (24 5 362)
G04726126Courtesy of BMW OF NORTH AMERICA, INC.

Oil sealing lip on shaft seal (1).

Screw in shaft seal (1) with special tools 24 5 366 and 24 5 364 as far as it will go.

Fig 9: Inserting Shaft Seal Special Tools (24 5 366) And (24 5 364)
G04726127Courtesy of BMW OF NORTH AMERICA, INC.