Preparation Of New Part

Make severance cut on new carrier support part in accordance with severance cut on vehicle.

Mark new part in accordance with severance cut on car and cut.

Open welded connections in areas (1) on both sides.

Open welded connections in area (2).

Detach remainder of reinforcement from engine support.

Fig 1: Identifying Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Open welded connections in areas (1).

Take off holder.

Fig 1: Identifying Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Adjust new parts to fit with alignment bracket or universal mount and secure.

Fig 2: Identifying Alignment Bracket Or Universal Mount

Courtesy of BMW OF NORTH AMERICA, INC.

In area (1) set ten 6.8 mm dia. holes for blind rivets N1.

Installation note:

In area (2) 2 N5 punch rivets are used later.

Fig 3: Identifying Rivet Areas

Courtesy of BMW OF NORTH AMERICA, INC.

In areas (1) and (2) set 6.8 mm dia. holes for blind rivets N1:

Area (1): 3 holes
Area (2): 2 holes

Fig 4: Identifying Rivet Areas
Courtesy of BMW OF NORTH AMERICA, INC.

In area (1) set seven 6.8 mm dia. holes for blind rivets N1.

Installation note:

In area (2) 1 N5 punch rivet is used later.

Fig 5: Identifying Rivet Areas

Courtesy of BMW OF NORTH AMERICA, INC.

In areas (1) to (4) set 6.8 mm dia. holes for blind rivets N1:

Open welded connections in area (1).

Installation note:

After adhesive has hardened, install 2 EMC SCREWS in areas (1) and (4).

Fig 6: Identifying Rivet Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Set two 6.8 mm dia. holes for blind rivets N1 in area (1).

Remove all new parts and deburr holes.

Fig 7: Identifying Rivet Areas

Courtesy of BMW OF NORTH AMERICA, INC.