67 62 020 Removing and installing/replacing flat motor for rear left or right power window unit

Necessary preliminary tasks

Release screws (1), tightening torque 51 35 1AZ .

Detach flat motor for power window unit (2) in direction of arrow from power window unit (3).

Installation:

Fit flat motor for power window unit (2) exactly on teeth of power window unit.

Fig 1: Detaching Flat Motor For Power Window Unit In Direction Of Arrow From Power Window Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

A normalisation must be carried out in order to activate anti-trapping protection.

Operating sequence for normalisation:

Operate corresponding power window switch in "Close" setting.
Once the upper end position has been reached, hold power window switch down for approx. 1 second more.

If necessary, repeat procedure again.

Normalisation is thus completed.

NOTE: Carry out function check (one-touch function, anti-trapping protection and, if necessary, comfort function).