67 62 000 Removing and installing/replacing flat motor for front left or right power window unit

Necessary preliminary tasks

Release screws (1).

Tightening torque 67 62 1AZ

Detach flat motor for power window unit (2) from power window unit and remove.

Installation:

Fit flat motor for power window unit (2) exactly on teeth of power window unit.

Carry out function check (one-touch function, anti-trapping protection and, if necessary, comfort function).

Fig 1: Identifying Screws And Power Window Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

A normalization must be carried out in order to activate anti-trapping protection.

Operating sequence for normalization:

Operate corresponding power window switch in "Close" setting.
Once the upper end position has been reached, hold power window switch down for approx. 1 second more.

Normalization is thus completed.