Special tools required

WARNING: Follow safety instructions for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Unclip protective cap (1) with special tool 00 9 341 and remove.

Fig 1: Identifying Protective Cap With Special Tool (00 9 341)

Courtesy of BMW OF NORTH AMERICA, INC.

Release mucket (1) in area of trim for front roof pillar (2).

Release screw (3), tightening torque, see 51 43 1AZ in 51 43 SIDE TRIM PANEL WITH ARMRESTS .

Unclip trim for front roof pillar (2) from mounting point (4).

Feed trim for front roof pillar (2) out of instrument panel trim (5) and remove.

Fig 2: Removing Trim For Front Roof Pillar Of Instrument Panel Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bore.

If necessary, replace faulty clip (1).

Make sure guides (3) of trim for front roof pillar (2) are correctly seated in associated mountings.

Position trim for front roof pillar (2) preassembled with clip (1) on associated bore and clip into place.

Fig 3: Identifying Front Roof Pillar Trim With Guides And Clip

Courtesy of BMW OF NORTH AMERICA, INC.