Necessary preliminary tasks

Version with roller sun blind:

Release screws (1).

Fig 1: Identifying Rear Door Trim Panel Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Start by unclipping door trim panel (2) at bottom.

Unclip clips (1) for door trim panel (2) with special tool 00 9 317 .

Fig 2: Identifying Door Trim Panel And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip door trim panel (1) at top from retainers (2) and remove.

Disconnect plug on power window switch.

Fig 3: Removing Door Trim Panel And Retainers

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook Bowden cable (1) from door lock (2).

Disconnect all plug connections and remove door trim panel.

Fig 4: Identifying Bowden Cable And Door Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure clips are installed in correct position.

Clips (1) are white.

Clip (2) is brown and shorter than clips (1).

If necessary, replace faulty clips.

Fig 5: Identifying White Clips And Brown Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

After assembling the door trim panel proceed as follows: