Necessary preliminary tasks

Remove REAR LIGHTS ON SIDE PANEL on left/right

Lever out cover (1) and release screw underneath.

Fig 1: Identifying Cover

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Release screw (1).

Bend wheel arch trim (2) in area (A) to one side.

Unscrew bolt (3).

Fig 2: Identifying Wheel Arch Trim With Screw And Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws.

Fig 3: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The operation is described on the left side; proceed in the same way for the right side.

IMPORTANT: Do not detach bumper trim (3) at sides (risk of damage).

Fig 4: Removing Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Press bumper trim (3) at point (1) downwards and at same time pull at point (2) in direction of arrow towards rear and top, thereby releasing from the catches.

Version with PDC:

Disconnect plug connection for ultrasonic transducers.

Remove bumper trim (1) towards rear with aid of a 2nd person.

Installation:

Catches on bumper trim (1) must not be damaged.

Fig 5: Locating Bumper Trim Catches

Courtesy of BMW OF NORTH AMERICA, INC.