3452516 Removing and installing/replacing DSC control unit

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks

IMPORTANT: Risk of damage to the contacts when removing and installing the hydraulic unit.

Release screws (1) and carefully detach control unit (2) towards front.

Fig 1: Identifying Front Brake Control Unit And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Replace all seals in area (1).

Fig 2: Identifying Seals Area

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Keep sealing faces clean.

Replace screws.

Observe tightening sequence (1-4).

Tightening torque 34 51 1AZ, see 34 51 SLIP CONTROL SYSTEM (DSC) . .

Fig 3: DSC Control Unit Bolts Tightening/Loosening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: