32 41 250 Removing and installing/replacing fluid reservoir for hydraulic steering
Special tools required:
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
DANGER OF INJURY if oil comes into contact with eyes and skin!
DANGER OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.
Close off line connections with seal plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable expansion tank.
Observe country-specific waste disposal regulations
Necessary preliminary work:
- Draw off and dispose of hydraulic fluid from fluid reservoir.
N45, N46, N46T, M47T2:
- Remove intake port if necessary with gaiter.
Release screw (1).
Tightening torque 32 41 1AZ .
NOTE:
If necessary, raise and/or turn fluid reservoir in order to gain better access to hose clamps.
Remove hose clamps if necessary with special tool 32 1 260 .
Disconnect intake pipe and radiator return line from fluid reservoir.
Lift out oil reservoir.
After installation:
- Fill and bleed HYDRAULIC SYSTEM .
- Check line connections for leaks.