54 34 128 Removing And Installing/Replacing Trim Panel For Cover Flap

WARNING: This page is about a different car, the 2013 BMW 135i, 2012 BMW 135i, and 2011 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For purposes of clarity, the cover flap is shown with the component removed.

Necessary preliminary tasks:

Remove TRIM STRIP FROM COVER FLAP .

Release left and right screws (1).

Fig 1: Identifying Left And Right Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip and remove trim of cover flap (2) as shown in the marked areas (1).

Installation:

Replace faulty clips (1).

Fig 2: Removing Trim Of Cover Flap

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws from seal lip (1) left and right. Modify seal lips

Modify clips (2).

Fig 3: Modifying Seal Lips

Courtesy of BMW OF NORTH AMERICA, INC.