51 43 148 Removing and installing or replacing panel for left or right door pillar

Lever out cap (6) and release screw underneath.

Remove coat hook (7).

Release side trim panel (1) at retainers (2) and clip (3).

Release trim panel (5) at clips (4) and remove in downward direction.

Installation:

If necessary, replace faulty clips (3 and 4).

Fig 1: Identifying Coat Hook, Retainers, Trim Panel, Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Complete removal only:

Lever out cap (1).

Release screw (2) and detach seat belt strap.

Tightening torque 72 11 5AZ .

Feed out seat belt strap from trim for door pillar.

Installation:

Check that spacer bushing (3) and rubber ring (4) are in correct position.

Fig 2: Identifying Seat Belt Strap, Spacer Bushing, Rubber Ring, Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Guides (1) on trim (2) must not be damaged.

Fig 3: Identifying Guides On Trim

Courtesy of BMW OF NORTH AMERICA, INC.