LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2011 >> 1M >> Repair and Diagnosis >> Electrical >> Gauges >> Body Equipment - Repair >> Reinforcement, Body >> 51 61 017 Removing and installing/replacing diagonal strut, front end, left

51 61 017 Removing and installing/replacing diagonal strut, front end, left

WARNING:

Scalding hazard!

Only perform work after engine has cooled down.

IMPORTANT:

Observe SAFETY INSTRUCTIONS for raising the vehicle

Driving without the diagonal strut is not permitted!

Necessary preliminary tasks: 

IMPORTANT:

Diagonal strut on right side must be installed in direction of travel ahead of diagonal strut on left side.

Release screws (1) and nuts (2).

Feed out diagonal strut (3) towards top.

Installation: 

Replace screws.

Replace self-locking nut.

Tightening torque 51 71 11AZ .

Fig 1: Identifying Feed Out Diagonal Strut With Screws And Nuts
G06180701Courtesy of BMW OF NORTH AMERICA, INC.