12 61 280 Removing and installing/replacing oil pressure sensor (N54T)
Necessary preliminary tasks:
- Switch off ignition.
- N54T only:
- Remove INTAKE SILENCER HOUSING .
WARNING:
Risk of burning!
Only perform this repair work on an engine that has cooled down.
Only perform this repair work on an engine that has cooled down.
Installation location:
Oil filter housing, front left.
Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.
Unlock connector (1) and remove.
Release oil pressure sensor (2).
Tightening torque 12 61 1AZ .
Installation note:
Check engine oil level, top up engine oil if necessary.