51 45 310 Removing and installing (replacing) center trim for instrument panel

Special tools required: 

• 00 9 340

A hard disk is installed in the Car Infotainment Computer (CIC).

Carry out mechanical work on the CIC and adjacent components with care.

Avoid subjecting the CIC to shaking/shocks.

Version without CCC/ASK or CIC: 

Unclip bottom trim (1) with special tool 00 9 340 .

Unclip top trim (1) with special tool 00 9 340 .

Pull out trim (1) and disconnect associated plug connection.

Replacement: 

• Remove OPERATOR UNIT FOR HEATER/AIR CONDITIONER
• If necessary, remove CENTER CONSOLE SWITCH CLUSTER
  Fig 2: Removing Top Trim Using Special Tool 00 9 340

  Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

If necessary, replace faulty holders (1).

Version with CCC/ASK or CIC: 

Remove CONTROL PANEL FOR HEATING AND AIR CONDITIONING SYSTEM .

Pull trim cover (1) inward to release from pin (2).

Detach trim cover (1) and disconnect plug connection.

Installation: 

Make sure ribbon cable (1) is positioned correctly on trim cover (2).

Replacement: 

If necessary, modify CENTER CONSOLE SWITCH CLUSTER (3)

Installation: 

If necessary, replace faulty holders (1).