51 23 105 Removing and installing/replacing right hood/bonnet lock (N52, N54)

Release screws (1) and remove intake duct (2).

Release screws (3) and feed out hood/bonnet lock (4) sideways.

Tightening torque 51 23 2AZ .

Fig 1: Identifying Screws, Intake Duct And Hood/Bonnet Lock

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Engine hood/bonnet lock (2) shown without attachment parts for purposes of clarity.

Disengage Bowden cable (1) from hood/bonnet lock (2).

Fig 2: Removing Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.