51 37 265 Removing and installing/replacing inner window cavity cover strip for door window, rear left or right
IMPORTANT:
The "INSTRUCTIONS ON FITTING WINDOW GUIDES " serve as the basis for this repair instructions and must be observed without fail.
Necessary preliminary tasks:
- * Release REAR SIDE TRIM PANEL UPPER SECTION and place to one side
NOTE:
Prior to removing the weather strip, pay attention to the exact installation position with respect to the adjoining components.
IMPORTANT:
- Risk of damage!
- If reusing the existing window cavity cover strip (3), make sure it is not bent.
Undo the lower section of side trim panel (1) above in the area of the B-pillar and pull inwards.
Release weather strip (3) from brackets (2) and pull off upwards beginning from the front.
Installation Note:
Coat weather strip (3) prior to fitting with APPROVED LUBRICANT .
Ensure weather strip (3) is fitted correctly.
Installation Note:
Catch (1) must not be damaged.