34 31 181 Removing and installing/replacing expansion tank for hydraulic brake actuation

Necessary preliminary tasks:

Read and comply with GENERAL INFORMATION .
Remove LOWER SECTION OF MICROFILTER HOUSING .

NOTE: Extract brake fluid out of expansion tank. Use a suction bottle used exclusively for drawing off brake fluid.
Do not reuse drawn out brake fluid.

Pull off supply hose (1) of clutch hydraulic system if necessary.

Unfasten plug connection (2) and disconnect.

Unlock quick-release fastener (3) and disconnect vacuum line.

Feed brake line out of rubber grommet and remove cover (4).

Fig 1: Identifying Plug Connection, Cover And Fastener

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip locking pin (1) from retaining lugs (2) and pull out locking pin.

Pull expansion tank in direction of arrow vertically out of brake master cylinder.

Fig 2: Pulling Expansion Tank

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Check rubber plug in brake master cylinder for damage and replace if necessary.
Push the expansion tank vertically onto the master brake cylinder.

Fig 3: Pushing Expansion Tank

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

BLEED BRAKING SYSTEM .