12 41 Starter motor with mounting
TIGHTENING TORQUE SPECIFICATION - STARTER MOTOR WITH MOUNTING
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Starter motor to crankcase | N54/N54T/N55 | M10x30 | 38 Nm | |
| 2AZ | Starter motor to transmission housing | N54/N54T/N55 | M10x85 | 38 Nm | |
| 3AZ | Alternator cable to positive battery connection point | N54/N54T/N55 | M8 | Flange nut | 15 Nm |
| N54/N54T | M8x14 | Hexagon screw 8.8 ZNS3 | 19 Nm | ||
| N54/N54T/N55 | M8 | Hexagon screw with internal Torx drive | 13 Nm | ||
| N54/N54T/N55 | M8 | Hexagon screw with dog point | 13 Nm | ||
| 4AZ | Ground cable to engine support arm/engine carrier | N54/N54T | M8 | 19 Nm | |
| 5AZ | Ground cable to longitudinal member | N54/N54T | M8 | 19 Nm | |
| 6AZ | Ground rail to longitudinal member | N54/N54T | M8 | 19 Nm | |
| 7AZ | Holder to crankcase | N54/N54T | M8x16 | 19 Nm | |
| 8AZ | Ground cable to transmission stand | N54/N54T | M8x16 | 19 Nm | |
| 9AZ | Ground cable to body | N54/N54T | M8 | 19 Nm | |
| 10AZ | Ground pin, battery positive terminal | N54/N54T | Self-tapping pin | 27Nm | |