51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left

Necessary preliminary tasks:

Detach mucket (1) in area of side trim panel (2).

Release bolt (3).

Remove hood/bonnet release lever (4) from side trim panel (2).

Fig 1: Removing Hood/Bonnet Release Lever From Side Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Unclip side trim panel (3) in direction of arrow from retaining points (2).

If necessary, disconnect associated plug connection and remove side trim panel (3).

Fig 2: Removing Side Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bore.

If necessary, replace faulty clips (1).

Position side trim panel (2) preinstalled with clips (1) on associated bores and clip into place.

Replacement:

Not E84:

Fig 3: Identifying Side Trim Panel And Clips

Courtesy of BMW OF NORTH AMERICA, INC.