51 71 482 Removing and installing/replacing left or right tension strut (on rear axle) (Convertible)

IMPORTANT:

Observe SAFETY INSTRUCTIONS for raising the vehicle

Driving without the trailing link is not permitted!

Left tension strut:

Release bolts (1, 3, 4, 5) and remove trailing link (2).

Installation note:

Replace screw (1, 3, 4, 5).

Make sure screws are installed in correct positions.

Fig 1: Identifying Trailing Link Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Right tension strut:

NOTE:

Remove left trailing link.

Loosen bolt (1, 3) and remove right trailing link (2).

Installation note:

Replace screws (1, 3).

Make sure screws are installed in correct positions.

Fig 2: Identifying Trailing Link Screws

Courtesy of BMW OF NORTH AMERICA, INC.