51 13 420 Removing and installing/replacing center rear-end trim section

Special tools required:

Necessary preliminary tasks:

Release screws (1).

Fig 1: Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Attach adhesive tape (1) underneath center rear-end trim section (2) (risk of damage).

Unclip clips (3) with special tool 00 9 317.

Pull off center rear-end trim section (2) in direction of arrow a little.

Fig 2: Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) at center rear-end trim section (2).

Remove center rear-end trim section (2).

Fig 3: Centre Rear-End Trim Section And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit all clips (1) with sealing ring.

If necessary, replace faulty clips (1).

Replacement:

Remove handle strip (3).

Fig 4: Handle Strip And Clips

Courtesy of BMW OF NORTH AMERICA, INC.