Applying adhesive

Apply K2 adhesive in areas (1).

Guide nozzle at an angle of max. 60° along adhesive flange.

Cross-section of adhesive bead approx. 4 - 5 x 10 mm.

Apply a short reference bead at an appropriate point for later checking.

Fig 1: Identifying Roof Outer Skin Bonding Surfaces

Courtesy of BMW OF NORTH AMERICA, INC.

Apply a little more adhesive K2 to nodes (1) of A- and C-pillars.

Fig 2: Identifying Adhesive K2 Applying Area To Nodes

Courtesy of BMW OF NORTH AMERICA, INC.

Apply a little less adhesive (1) in area of holders (1).

Fig 3: Identifying Adhesive Area Of Holders

Courtesy of BMW OF NORTH AMERICA, INC.