41 11 095 Replacing Left Engine Support In Front Of Wheel Arch

Follow procedure for REPAIR STAGE 3 .

Read relevant service information under BODY .

Use only APPROVED SPOT-WELDING APPARATUS  for repairs.

Place vehicle on straightening bench.

Necessary preliminary work: 

REMOVE CARRIER SUPPORT 

The following new body parts are required (refer to ELECTRONIC PARTS CATALOGUE ):

• (1) Engine support, front
  Fig 1: Identifying Engine Support

  Courtesy of BMW OF NORTH AMERICA, INC.

  Mark severance cut in accordance with Dimension a and cut.

  Dimension a=40 mm before wheel arch edge.

  Remove section of engine support.

  Installation note: 

  Mark severance cut on new part in accordance with vehicle and cut.

  Adjust new part to fit with alignment bracket or universal mount.

  Fig 2: Identifying Section Of Engine Support

  Courtesy of BMW OF NORTH AMERICA, INC.

  Weld in REINFORCEMENT PLATE  at severance cut.