41 11 015 Replacing Left Engine Support With Wheel Arch: Notes
Observe procedure for REPAIR STAGE 3 .
Read relevant service information under BODY .
Steel-aluminium composite construction is used on the vehicle. Observe specific procedures in BONDING ALUMINIUM ON STEEL and OPENING RIVET CONNECTIONS .
Spot-weld bonding is used on this vehicle. Observe specific procedure. See SPOT-WELD BONDING STEEL COMPONENTS and OPENING ADHESIVE BONDS .
Use only approved SPOT-WELDING APPARATUS for repairs.
Place vehicle on straightening bench.
The following new body parts are required (see BMW Electronic Parts Catalogue):
- (1) Engine support
- (2) Engine support, rear
- (3) Wheel arch, front
- (4) Connection, wheel arch/entrance
- (5) Connection, side frame, rear
- (6) Shaped parts, carrier support, wheel arch, front (not shown)
Following CONSUMABLES are required:
| Material | Quantity |
|---|---|
| Adhesive K1 | 1 |
| Blind rivets N2 | 25 |
| Cleaning agent R1 | 1 |
| Cavity sealing wax remover | 1 |
| Sealant D1 |