Installing actuator

Connect plug (1) to actuator.

Fig 1: Connecting Plug To Actuator

Courtesy of BMW OF NORTH AMERICA, INC.

Secure actuator screws (2).

Tighten screws hand-tight only .

Fig 2: Identifying Actuator Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Insert screws (1) and tighten down

Tightening torque: see 5AZ in 41 61 ENGINE COMPARTMENT LID

Fig 3: Identifying Actuator Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Tightening torque: see 4AZ in 41 61 ENGINE COMPARTMENT LID

Fig 4: Identifying Actuator Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Fit resetter (2).

Remove retaining screws (1).

IMPORTANT: After the actuator has been installed, retaining screws (1) must be removed again!
If the retaining screws are not removed after the actuator has been installed, active pedestrian protection will not function.

Fig 5: Identifying Actuator Retaining Screws And Resetter

Courtesy of BMW OF NORTH AMERICA, INC.

Seal holes of retaining screws with protective caps.

Comply with notes regarding handling active PEDESTRIAN PROTECTION .