Stamping second vehicle identification number

Display input:

NOTE: With Layout 2 the already entered vehicle identification number is stamped in line 2.

Fig 1: Identifying Display Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Start stamping operation with pushbutton (2).

After the stamping operation, if necessary adapt ENGINE COMPARTMENT LID SEAL LOCATOR of second vehicle identification number.

Fig 2: Pressing Pushbutton For Vacuum Pressure And Pushbutton For Start Stamping Operation

Courtesy of BMW OF NORTH AMERICA, INC.

Following layout functions are available:

Layout selection	Vehicle identification number
Layout 1	In line 1
Layout 2	In line 2
Layout 3	Turned through 180° in line 1
Layout 4	Turned through 180° in line 2
Layout 5	Cross through in line 1
Layout 6	Cross through in line 2