Procedure for additional vehicle identification number

Mark position lines (2) in accordance with specified dimensions/measurements.

Dimension a = 12 mm

Dimension b = 10 mm

Fig 1: Identifying Original Vehicle Identification Number And Position Lines

Courtesy of BMW OF NORTH AMERICA, INC.

Display input:

NOTE: With Layout 5 the vehicle identification number (line 1) is crossed through.

Fig 2: Identifying Display Unit

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Perform stamping operation with position lines in advance on a test sheet.

Move suction feet of needle stamping unit to positions (1) and (2) shown.

NOTE: The contact surface for the suction cups of the needle imprint device must be dry and free of dust and grease!

Make sure the unit is resting securely in position. If necessary, adjust the height and position of the suction feet.

Fig 3: Identifying Needle Stamping Unit Positions

Courtesy of BMW OF NORTH AMERICA, INC.

Press pushbutton (1) for vacuum pressure.

Then start stamping operation with pushbutton (2).

IMPORTANT: After completing the stamping operation, do not alter the position of the unit.

Do not switch off vacuum pressure.

Fig 4: Pressing Pushbutton For Vacuum Pressure And Pushbutton For Start Stamping Operation

Courtesy of BMW OF NORTH AMERICA, INC.