22 11 100 Replacing right engine support arm (N62)
Necessary preliminary tasks:
- Secure engine in installation position.
- Remove both front wheels .
- Remove underbody protection.
- Remove reinforcement plate . See 31 10 010 REMOVING AND INSTALLING/REPLACING REINFORCEMENT PLATE .
- Lower front axle support . See FRONT SUB-FRAME
Observe safety instructions on raising the vehicle . See 00 MAINTENANCE AND GENERAL INFORMATION .
Release grounding strap (1) from engine support arm.
NOTE:
Clean contact surfaces to ensure a safe ground connection.
Release screws (2) and nut (3) and remove engine support arm.
Release screws (2) and nut (3) and remove engine support arm.
Tightening torque 22 11 2AZ/3AZ . See ENGINE AND GEARBOX SUSPENSION (MOUNTS) - TIGHTENING TORQUES .